1. Over all system configuration

• CPU Atheros AR7161 MIPS 24K running @ 680MHz
  
• MEMORY DDR 64MB
  
• FLASH SPI 16MB
  
• Three MINI-PCI Slots supports Type IIIA
  
• One USB 2.0 Host
  
• One UART

2. Power Supply Range 12VDC to 24VDC

• Using Higher voltage is recommended since it will use lower current
  
• Typical Power Consumption is 3W idle no radios present
  
• 5W idle One Radio present
  
• 7W while passing 100Mbps traffic
  
• Single RJ45 "J1" Is for WAN and Passive Power Over Ethernet
  

3. Ethernet Interface

• J1 Single WAN port 10/100
• J2 Dual Lan Port 10/100
• Ethernet Phy switch, ADMTEK "Infineon" ADM6996FC

4. Supported IO

UART J5 6 pin Header
Terminal Settings 115200 baud, 8 bits, nor parity, 1 stop bit.

USB 2.0 Host J7
5 Pin Header typical PC USB header

JTAG Port "J4"
14 Pin header

USER GPIO Header "J33"
Single Row 7 Pin Header Also next to it J5 dual row header to enable pull-up or pull-down for each GPIO user selectable in case User needs Active Low or Active High GPIO

J33 Pin out and Strapping option "place shunt to enable strapping option"

5. RESET BUTTON "SW4"

Uses GPIO_8 with weak pull-up, Active Low, for Resting back to factory defaults or multiple functions software dependent.

6. LED INDICATORS